The service life of solar road stud is limited. We must ensure no mistakes in the installation process, in order to make the solar road stud work normally and maintain a certain efficiency within its service life.
The size of the solar road stud is very small, but it is easy to be crushed by vehicles when solar stud is installed in the middle or edge of the road, which will cause damage to the solar road stud. The light reflected by the solar road stud depends on the reflector, so once the reflector is damaged or polluted, it will lose its reflective ability. And the solar road stud is always exposed to the outside, it is easy to have oil, dust accumulation and even into the interior of the solar road stud. In these cases, solar road stud can not fulfill its mission.
First of all, we ensure that the solar road stud installation position is clean. The firmness of road stud depends on the close combination of solar road stud, glue and ground. If the installation position is not clean, the dust will absorb most of the adhesive force of the glue, resulting in poor bonding of the road stud. At this time, when the road stud is impacted by external force, it is easy to fall off.
Then, we have to find the right location for the solar road stud. It is not allowed to install the road stud with shallow hole position and thin hole position, which is mainly for cast aluminum solar road stud with shank. Because of its part deep into the ground, cast aluminum solar road stud has better impact resistance, compression resistance and longer service life.
But in the process of installation, if the hole position of the solar road stud is too shallow or too thin, the bottom of the solar stud can not fully contact with the ground, which will affect the bonding firmness.
